Got mine yesterday. Set it up. Cuts very fast. My concern is when I put a straight edge against the fence vertically, it only touches the fence at the top and bottom. There’s about a 0.025″ gap in the middle. Is this a concern for accuracy? I guess I could add a thin piece of hardwood to the face of the fence to make it more flat and perpendicular. I also don’t find an adjustment for the perpendicularity of the fence face to the table. Any thoughts?

Further testing showed that the red “Stop” lever was the cause, not the power switch.  After turning on the saw, the red stop lever would drop too hard onto the stop button and turn the saw off.   After conferring with the product manager at Dewalt, it was determined that the red stop lever spring force was too high.  The units we tested was from a “manufacturing sample lot.”  MSL’s are the first time the plant does a big run of the product and Dewalt then has time to refine and make adjustments, before the tool goes to production.

best table saw 2020 Amazon.com

×