With a maximum cut depth of 3.125 inches and a 32.5-inch rip capacity, the 10-inch blade of this DeWalt table saw handled all the relatively light-duty board ripping I needed from it, but I also tested it against a variety of plywood and other board sizes to assess its capability. The 15-amp motor is fairly standard for this contractor or job site level of table saw, and none of the boards I threw at it caused it to bind—good news, as binding is at best annoying and at worst dangerous.
Chris – Great question. If you break it down a bit you can see why. The table saw uses a much smaller blade so the demand on that saw is actually quite a bit less. Also, if you make the table saw 120, you need another battery, and the conversion cable….the saw becomes VERY expensive. Just my two cents…but I’m fairly sure this is what kept it at 60v….it’s damn impressive though.
The DeWalt doesn’t go above and beyond here but has some standard safety equipment as part of its Site-Pro Guarding System. The Blade Guard Assembly is a standard clear plastic set of guards that allows the wood to be fed to the blade but shields you from putting hands on the exposed blade in a slip. The guards will lock in a raised position when you need to see the blade—for example, when adjusting the blade height—which lessens the temptation to remove this safety feature when it’s in your way.
This particular Dewalt table saw is our choice for commercial use. It features a 15-amp motor, which has an amazing speed of 4800 rpm. So, if you’re looking for a saw that incorporates high torque and power, this is one you shouldn’t pass up. The high number of spins in a minute can rip through several types of woods, which is why this model is ideal for different types of applications.
Further testing showed that the red “Stop” lever was the cause, not the power switch.  After turning on the saw, the red stop lever would drop too hard onto the stop button and turn the saw off.   After conferring with the product manager at Dewalt, it was determined that the red stop lever spring force was too high.  The units we tested was from a “manufacturing sample lot.”  MSL’s are the first time the plant does a big run of the product and Dewalt then has time to refine and make adjustments, before the tool goes to production.

best table saw 2020 Amazon.com

×